Citizen Systems iDP-562 - Manual (Page 27)

iDP-562 User’s Manual
CITIZEN 22
7. Control Code
Control codes are the same for 7 BIT DATA and 8 BIT DATA except SI & SO code.
7.1 SI & SO Code
Symbol 8 BIT DATA 7 BIT DATA
SI Standard character designation (Same as US) Designation of SI side character
SO Enlarged character designation (Same as RS) Designation of SO side character
7.2 Function Code
Symbol Code Function
( Hexadecimal)
LF 0A Feeds a new line after printing.
CR 0D Feeds a new line after printing.
You can select CR function in accordance with
your computer's output. For details, refer to
5.5 Setting the Preset Jumper.
RS 1E Enhanced character designation.
The designation is released with US code or line feed.
US 1F Standard character designation.
FF 0C Carries out from feed performance after printing.
DC1 11 Makes the printer SELECT (ON-LINE) state.
Only this code can be accepted irrespective of
DESELECT (OFF-LINE) state.
DC2 12 Red printing is specified / released.
Designation / release (alternative) of red one line
printing is possible with this code.
DC3 13 Makes the printer DESELECT (ON-LINE) state.
Designation / release of reverse printing.
DC4 14 Designation / release (alternative) of reverse printing
is possible with this code.
CAN 18 Clears the print data in the buffer.
All the previous input data is cleared with this code.
Graphic print (correspondence with bit) mode designation.
*ESC + "K" 1B, 4B It is not possible to print graphic mode and another character
mode in one line.
ESC + "C" 1B, 43 Page length designation and paging action.
Refer to 7.3.
ESC + "0" 1B, 4F Paging is off
*ESC + "1" 1B, 31 2.75mm line spacing.
*ESC + "2" 1B, 32 5.5mm line spacing.
* Only for iDP-562-RS and iDP-562CN type.