Char-Broil 463230511 - Manual (Page 26)

Grease Tray
Grease Pan
15
16
• (over-fill protection device)
to grill and regulator.
• Place Lp tank into hole in bottom shelf with tank collar opening facing to side as shown. Finger tighten tank retainer screw to hold
LP tank securely in place.
LP tank is sold separately. Use only with an OPD equipped LP tank. Fill and leak-check before attaching
See Use and Care section to correctly Leak Test and perform the Burner Flame Check.
Insert regulator through the large hole on left side panel.
LP Cylinder
(not included)
CAUTION
Failure to install tank correctly may
allow gas hose to be damaged in
operation, resulting in the risk of fire.
LP Tank
LP Cylinder
(not included)
Always keep LP cylinders in
upright position during use,
transport, and storage.
Regulator
Cylinder screw at rear of cart
Tank Retainer Screw
• Attach the heat shield to grease tray with #8-32x3/8” sheet metal screws (A).
• Place grease pan into grease tray, then place the tray into the cart (B).
A
B
Heat Shield
Grease Tray
CAUTION
Failure to install grease tray and
grease pan will cause hot grease to
drip from bottom of grill with risk of
fire or property damage.
26
Sheet Metal Screws
Qty. 2
#8-32x3/8"