Jaypro Sports FBGP-620 - Manual (Page 6)

T:\Aftermarket\Football\Drawings\FBGP-620\SPECIFICATIONS\FBGP-620 Installs.doc 8/14/2012 5
Insert the end fitting in crossbar and loosely install the appropriate hardware. Verify that
the vertical member is square to the crossbar and plumb.
Attach top upright cap:
Install the upright cap on the top upright. The cap goes on the end without holes. Tap
the cap in place and drill a 1/8” through the hole on the cap to the top upright. Uses the
self-tapping screws provided and secure the cap.
Install wind streamers (if purchased).
Remove the hardware holding the end fitting and rotate it down so the top upright can be
slid on. Using the 3/8” hardware provided attach the upright to the end fitting. It is
recommended that a silicon sealant be used on both sides of the hardware to prevent
corrosion. Once the top upright is connected, balance the top upright on a ladder, so the
upright can be pulled to vertical and fastened.