Jaypro Sports FBGP-620 - Manual (Page 2)

T:\Aftermarket\Football\Drawings\FBGP-620\SPECIFICATIONS\FBGP-620 Installs.doc 8/14/2012 1
FBGP-620 SERIES
OFFICIAL 5’ OFFSET FOOTBALL GOAL POST
- PERMANENT AND SEMI-PERMANENT INSTALLATIONS -
LIST OF MATERIALS
ITEM NO. PART NO. DESCRIPTION QTY.
1 HS5119 Bolt-HX HD ½”-13x5” 8
2 HS5066 Bolt-HX HD ½”-13x7 ¾” 4
3 HN268 ½”-13 LOCK NUT 12
4 HW2044 ½” FLAT WASHER 12
5 HS1616 Bolt-3/8”-16x2 ¾” 8
6 HN1230 3/8”-16 LOCK NUT 8
7 HW2047 3/8” FLAT WASHER 8
8 SR167 ½-13 x 8 in THREADED ROD 1
9 HN5038 ½-13 FLANGE NUT 2
IMPORTANT
1) The location of the gooseneck with respect to the field is critical. By rule, the
front of the crossbar should be even with the field side (inside) edge of the end
line such that the crossbars measure 360 ft apart inside to inside. The distance
from the end line to centerline of the bottom upright (gooseneck) is approximately
62 1/4” for the FBGP-620 series. See Figure 1
2) The footing depth is dependant on the type of installation, permanent or semi-
permanent. For permanent installations see Figure 3. For a semi-permanent using
a ground sleeve (Part No. FBSLV5) see Figure 4, and for a semi-permanent with
height adjuster see Figure 5. Materials for the semi-permanent with height
adjuster installation (Part No. FBGPGS-5) include the ground sleeve, height
adjuster and hardware.
3) Concrete should be a minimum 4000-psi mix.
4) The crossbar should be level and at a height of 10 ft above ground level. The
uprights should be plumb in both directions, front to back and side to side.
Adjust goal components as necessary. Note that a certain amount of deflection in
the crossbar is to be expected due to the weight of the end fittings and uprights on
each end.