Jaypro Sports FBGP-720 - Manual (Page 11)

DETAIL A DETAIL B
1
1
2
2
3
3
4
4
A A
B B
SIZE: SCALE: REV.: DRAWING NAME: PART NUMBER: SHEET:
B N/A D FBGPGS-6 FBGPGS-6 1 1 OF
TITLE: INITIALS: DATE:
DESIGNER:
CHECKER:
DC
BTS
7/19/2006
3/6/2006
THIS DRAWING IS THE SOLE PROPERTY OF JAYPRO SPORTS INC. AND MAY NOT BE REPRODUCED
WITHOUT WRITTEN PERMISSION OR CONSENT
PROJECTION METHOD:
UNLESS OTHERWISE SPECIFIED
TOLERANCES:
0. = .13
0.0 = .06
0.00 = .03
PHONE:
800.243.0533 (TOLL FREE)
860.447.3001 (LOCAL)
FAX:
800.444.1779 (SALES)
860.440.0628 (ENG.)
JAYPRO SPORTS, LLC, 976 HARTFORD TURNPIKE, WATERFORD, CT 06385 USA
T:\Aftermarket\Football\Drawings\FGBP-720\GOOSENECK-SLEEVE\FBGPGS-6 GOAL ASSSEMBLY.idw
FIGURE 5
ANTI-ROTATION ROD
1/2-13 x 8 in
JACKING SCREW
1/2-13 x 2 in HEX BOLT
WITH JAM NUT TYPICAL
3 PLACES
1/2-13 FLANGE NUTS
USE OF GROUND SLEEVE WITH HEIGHT ADJUSTER:
1. SET DEPTH OF GROUND SLEEVE TO 51 in FROM GROUND SURFACE
2. AFTER CONCRETE HAS CURED, MEASURE DISTANCE FROM GROUND SURFACE TO BOTTOM OF INSIDE OF
GROUND SLEEVE. THIS IS DEPTH B AS SHOWN
3. ADJUST HEIGHT ADJUSTER SPACING C, ACCORDING TO FOLLOWING FORMULA
C = B - 48''
4. INSERT THE HEIGHT ADJUSTER INTO THE BOTTOM OF THE GOOSENECK ORIENTED AS SHOWN. DRILL (2)
HOLES (Ø7/32 OR Ø15/64) THROUGH THE GOOSENECK WITHIN 2 TO 3 INCHES FROM THE BOTTOM AND USE
THE SUPPLIED 1/4 in SELF TAPPING SCREWS (2x) TO HOLD THE HEIGHT ADJUSTER IN PLACE. SEE DETAIL B
5. INSERT GOOSENECK INTO GROUND SLEEVE. ALIGN WITH PLAYING FIELD.
6. PLUMB /CENTER THE GOOSENECK BY ADJUSTING THE 3 JACKING SCREWS.
7. DRILL 11/16'' DIA HOLES IN GOOSENECK THROUGH PRE-DRILLED HOLES IN GROUND SLEEVE. INSERT
ANTI-ROTATIONAL ROD THROUGH GROUND SLEEVE AND FASTEN BOTH SIDES WITH SUPPLIED NUTS. SEE
DETAIL A
FOOTING DETAIL
GROUND SURFACE
6 in MIN
51 in
DEPTH B
57 in
36 in
4 in
5 in
(3 in NOMINAL)
SPACING C
HEIGHT ADJUSTER
JAM NUTS (OPTIONAL)
1-8
1/4-14 x 1/2'' SELF TAPPING SCREWS
78 in
TO INSIDE EDGE
OF ENDZONE END LINE FIELD SIDE
REV DESCRIPTION DATE BY
D REVISED SLEEVE DEPTH 7/15/2010 DRL