Jaypro Sports WMSS User Manual

Page 11

11 of 13

5. Screw on static mixer.
6. Put holder/cartridge into appropriate dispenser and discard first two trigger pulls of adhesive

from each refill pack or cartridge.

7. Inject adhesive into hole starting at the bottom until 1/3 to 2/3 full. Use mixer filler tube

extensions when needed to reach the hole bottom.

8. Unlock dispenser.

9. Insert rod. Twist during installation.
10. Fastener may be adjusted during specified gel time.
11. Do not disturb anchor between specified gel time and cure time.
12. Apply specified torque as required to secure items to be fastened. Do not exceed maximum

torque specified.

See applicable Hilti Kwik Bolt tables below for gel and cure time information. Remember to

consult Hilti directly for complete specifications and installation instructions. The information included
herein is intended as a guide only for assistance in proper anchor selection. HAS rod information
shown but other acceptable anchors are available from Hilti.

Figure 8: Gel and Cure Times for Kwik Bolt 3 (Adhesive Anchor)