Intex CS15110 Krystal Clear 2012 - Manual (Page 30)

163
SAVE THESE INSTRUCTIONS
Page 30
(163) MODEL CS15110 SAND FILTER PUMP & FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 11/08/2011
English
POOL CARE & CHEMICALS
• All pools require care to keep the water clear and hygienically clean. With proper
chemical control, your filter will help attain this objective. Consult your pool supply dealer
for instructions regarding the proper use of chlorine, algaecide and other chemical
agents required for sparkling clear water.
• Keep pool chemicals away from children.
• Do not replenish chemicals in pool while pool is occupied. Skin or eye irritations could
occur.
• Daily pH checking and chemical treatment of the water is very important and cannot be
overemphasized. Maintenance of proper pH levels are required when filling the pool as
well as during the season. Consult your local swimming pool supply store for
instructions.
• The season's first filling of the pool may have brackish water requiring extra water
additives and extra filtering time. Do not allow swimming in pool until the pH level is
balanced. Consult your local swimming pool supply store for instructions.
• Chlorinated water may damage lawns, gardens or shrubbery as children play in the pool
and splash water outside the pool. Lawn areas underneath the pool liner will be
destroyed. Note that some types of grass may grow through the liner.
• Filter run time depends on pool size, weather and usage level. Experiment with various
run times so as to produce clean clear water.
MM
AA
IINN
TT
EE
NN
AA
NN
CC
EE
MAINTENANCE (continued)
The Copper Ion Test Strips can be used to test the copper ion concentration in the water.
Directions and Use
1.
Dip the entire strip into the water for 3 seconds, then remove it.
2. Hold the strip level for 15 seconds. Do not shake excess water from the strip.
3. Now compare the copper ion strip pad to the color chart on the packaging label.
The 3-Way Test Strips can test the “Free Chlorine”, “pH”, and “Total Alkalinity” levels at the
same time. We recommend that you test the water chemistry weekly, and maintain the
chlorine concentration at 0.4-1.5 ppm.
Directions and Use
1.
Dip the entire strip into the water and remove immediately.
2. Hold the strip level for 15 seconds. Do not shake excess water from the strip.
3. Now compare the strip pad to the color chart on the packaging label. If necessary,
adjust the chemical level in the pool water. It is very important, to use the proper
technique when testing the water's chemical level. Read and follow the written strip
instructions carefully.
INTEX ® 3-WAY TEST STRIPS (PACKED WITH THE PRODUCT)
INTEX ® COPPER ION TEST STRIPS (PACKED WITH THE PRODUCT)