Intex CS15110 Krystal Clear 2012 User Manual

Page 21

163

SAVE THESE INSTRUCTIONS

Page 21

(163) MODEL CS15110 SAND FILTER PUMP & FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 11/08/2011

English

SALTWATER SYSTEM OPERATION (continued)

IINN

IIOO

Boost cycle

•

If the test result is below 0.1ppm, press and hold “BOOST”
button for 5 seconds until the indicator lights up and the
LED display display “80”. This indicates that the saltwater
system has started copper ion and more chlorine sanitizer
production. You can press and hold the “BOOST” button for
another 5 seconds until the indicator is off, which will cancel
the Boost cycle.
Note: Once the system has started copper ion and more
chlorine sanitizer production, the boost button can’t be re-set until the power
switch is off.

•

The boost operating hours is 4 times the amount of time programmed into the
system, i.e. if your saltwater system operating time is 2 hours, the boost procedure
will run 4 x 2 = 8 hours. After boost procedure has been completed, the system
will automatically switch to the normal working mode.

•

After a heavy rain or if the pool is dirty, press the “BOOST” button to shock the
pool again.

Test pool water regularly:
Once the copper level appears to be balanced, test the pool water every week
to maintain the proper sanitizer level.
It’s very important that the free chlorine is between 0.4-1.5 ppm and copper
ion concentration is between 0.1~0.2 ppm. When the copper level is below 0.1
ppm, repeat step 6.
NOTE: A High copper ion concentration may cause blonde hair to exhibit a
green hair. To prevent this, wear a swimming cap during swimming, and wash
hair with special shampoo after using the pool.
See “Troubleshooting Guide”.

Stand-by/power saving mode:

•

When the cycle ends, the green “SLEEP” indicator on the
control panel lights up and the LED display flashes “93”.
The system is now in Stand-By mode. After a while, it
shuts down and sets itself in a Power Saving mode. The
system will automatically turn itself back on in 24 hours,
starting its daily cycle of chlorine production.

•

The “SLEEP” indicator stays on, while the system is in the
Power Saving mode. The LED display however, goes blank
after 1 hour. Press any button ( or ) to view the last LED
code.

Running the pump alone without the Saltwater System:
To run the pump alone without the Saltwater System function,
press and hold both ( ) and ( ) buttons for 5 seconds
until you hear a “beep” and the LED display shows “FP”.
The pump is now operating alone. To stop the pump,
manually turn the switch OFF. NOTE: The pump cannot
be operated alone under an automatic timer mode.

IMPORTANT: To keep the initial automatic operating cycle
setting of the Saltwater System, turn the switch ON, the
LED display shows “FP”, then unlock and lock the keypad
controls again, see previous steps 2 and 3. The LED display shows
the initial input hours and the Saltwater System cycle repeats again.