Intex CS15110 Krystal Clear 2012 - Manual (Page 20)

163
SAVE THESE INSTRUCTIONS
Page 20
(163) MODEL CS15110 SAND FILTER PUMP & FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 11/08/2011
English
SALTWATER SYSTEM OPERATION
OO
PP
EE
RR
AA
TT
IINN
GG
II
NN
SS
TT
RR
UU
CC
TT
IIOO
NN
SS
1. Start up the unit:
Plug the power cord into the electrical outlet and test
the GFCI/RCD (circuit breaker). Switch on the unit.
With the Filter Pump turned “ON” and operating.
Flashing code“00” appears on the electronic control
station’s LED, indicating that the unit is ready to be
programmed.
2. Set operating hours for Saltwater System:
With code “00” flashing, press button to
set the desired operating hours. See the
“Operating Time Table” for the required
operating hours related to each pool size.
Pressing will increase the time from 01
to 12 hours maximum. If you have selected
too many hours keep pressing to repeat
the cycle. The built-in timer will now activate
your Saltwater System, at the same time
each day, for the number of hours you have set.
NOTE: The Saltwater System will not operate if the filter pump is not operating.
3. Lock keypad controls:
With the desired hour value showing, press
button until
you hear a “beep”. The green “WORKING” indicator on the
control panel will light up within a few seconds to indicate that
the saltwater system has started sanitizer production. Locking
the control buttons into this setting prevents unauthorized
changing of the operating cycle.
NOTE: If you forget to lock the keypad controls, the system will
automatically lock it and start working 1 minute later.
4. Readjust operating time if necessary:
The operating hours can be re-adjusted if necessary.
Press button until you hear a “beep” to unlock the
keypad and the current programmed time will flash.
Repeat steps 2 to 3.
5. Test the copper concentration in the
pool water.
The Saltwater System recommends a copper level of 0.1 to 0.2 ppm.
This is easily tested by the copper ion test strips provided. If the test result is
0.1~0.2ppm, go directly to step 7.
(1 to 12 hours max per cycle)
OK
0
Copper (ppm)
0.1 0.2 0.5 0.9 1.3