Intex CS15110 Krystal Clear 2012 - Manual (Page 28)

163
SAVE THESE INSTRUCTIONS
Page 28
(163) MODEL CS15110 SAND FILTER PUMP & FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 11/08/2011
English
MM
AA
IINN
TT
EE
NN
AA
NN
CC
EE
MOTOR PRE-FILTER CLEANING AND MAINTENANCE
1. Make sure the filter pump is switched off, then disconnect the power cord from
the electrical outlet.
2. Grasp a plunger valve handle. Turn the handle counter-clockwise, push down
until it stops and then turn it clockwise until the plastic protruding notch anchors
in the "0/1" position. Repeat for the second plunger valve. This prevents the
water from flowing out of the pool.
3. Release the pressure first by opening the
sediment release valve (19) located
on the lower side of the pre-filter housing
(see drawing 34).
4. In a counter-clockwise motion unscrew the
leaf trap cover (14), then remove the
basket (16) and leaf trap o-ring (15) from the
pre-filter housing (see drawing 35).
5. Empty and flush the basket using a garden
hose, may use a plastic brush to remove
deposits from the basket. Do not use metal
brush.
6. Clean and rinse the inside of the pre-filter
housing and the leaf trap O-ring with
a garden hose.
7. Reinstall the leaf trap O-ring, basket and leaf
trap cover to the pre-filter housing.
8. Close the sediment release valve (19) back.
1
2
34
35
F FLLO OW W S SE EN NS SO OR R C CLLE EA AN NIIN NG G
19
14
16
15
1. In a counter-clockwise motion unscrew the collar of the flow sensor (21)
and remove it from the electrolytic cell conduit (22). See “Part Reference”.
2. If deposits and debris are seen on the surface of the flow sensor, then use
a garden hose to wash it off.
3. If flushing with water does not remove the deposits, use a plastic brush to
clean the surface and the hinge if necessary. Do not use a metal brush.
4. After the flow sensor has been inspected and cleaned, align the locator
notch on the flow sensor to the connection ridge in the conduit. Now turn
the collar in a clockwise motion, tightening the sensor back into its position.
Do not overtighten.
Connection Ridge Locator Notch Hinge
41