ClearSounds SW200 - Manual (Page 15)

15 – ENGLISH
█
TELEPHONE RING SIGNALER
If you choose to connect the Shake Up Wake Up to your
telephone line, it will notify you when there is an incoming
phone call.
The sound ring selection is controlled by a separate switch
located on the back of the clock. You must activate the Sound
Alarm key to activate the telephone sound ringer.
Additionally, any notifications that you have activated (LED
flasher/lamp and shaker) for alarm clock notification will also
alert you to the telephone ringing.
1. Connect one end of the included telephone cord to the LINE
IN jack on the clock and connect the other end of the cord
to the phone jack in the wall.
2. Make sure the AC power plug is connected to a standard AC
wall outlet or surge protector.
3. Select Ring Tone 1-3 located on the back of the clock.
4. Be sure the notifications that you desire for telephone
ring signaling (sound alarm, LED flasher/lamp, shaker)
are activated.
5. Optional : Connect your telephone to the LINE OUT
jack. This will allow you to use that telephone from the
clock location.
When the clock alerts you to an incoming call, simply answer
any phone and the alarm will stop. After you hang up, your
clock is ready to alert the next call.
2 3 1