ClearSounds SW200 User Manual
Page 13
13 – ENGLISH
█
SET THE ALARM AND SOUND, VISUAL AND
SHAKER NOTIFICATION
This clock offers 2 separate alarms that can be set for
different times. Alarm 1 is displayed as 1 and Alarm 2 is
displayed as 2. When either alarm is switched On, the blue
backlighting will appear on the Set Alarm key. The snooze
bar will also light red when either alarm is switched On.
If neither alarm is turned On, the snooze bar will not be lit.
Note
: You must activate the alarm notification modes that you
wish to use. See Alarm Notification Modes and Activation
on pages 9-11.
To set your alarm
1. Press Set Alarm and “1” will be blinking on the
left side of the display.
2. Press Up or Down to select the alarm (alarm 1
or alarm 2) you want to set and then press Set Alarm .
3. The current On/Off status for that alarm will blink. Press
Up
or Down to select On or Off and then
press Set Alarm .
4. The current alarm hour will blink. Press Up or Down
to change the hour and then Press Set Alarm .
5. The current alarm minute will blink. Press Up or
Down
to change the minute and then Press
Set Alarm
.