ClearSounds SW200 - Manual (Page 10)

10 – ENGLISH
LED/optional Lamp Flashing
Press and hold the LED Flash key to activate the LED
flasher function. If you have plugged a lamp into the clock, it
will also flash when the alarm goes off.
Vibrating Pad Jacks
You can connect a vibrating pad to each of the vibrating pad
jacks on the back of the clock. Jack A is used for Alarm 1 and
Jack B is used for Alarm 2. Each shaker operates independently.
Simply plugging the shaker in to the jack and activating
the shaker function will allow the shaker to vibrate during the
scheduled alarm time.
Press and hold the Shaker key to activate the
shaker function.
SOUND ALARM
Adjustable Volume Control
The Volume control increases or decreases the loudness of the
alarm, which can go as high as 87 dB. The volume control
is adjustable for all 3 sound alarm patterns (see pg. 11 for
more information about sound alarm patterns). To adjust the
volume, roll the slide wheel up to make it louder and down to
make it softer.
Adjustable Tone Control
The Tone control shapes the sound by changing the frequencies
of the alarm. The tone control only works for sound alarm
Pattern 1 (see page 11 for more information about sound
alarm patterns).