Char-Broil COMMERICAL 463248708 - Manual (Page 19)

First, remove the two screws and lock washers factory attached to the sideburner valve bracket. Position sideburner
valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes
on valve bracket with left and right holes on fascia. Secure using lock washers and screws that were removed from bracket.
Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on
fascia. Attach using two
#8-32x3/8” screws and 4mm lock washers. Press sideburner control knob onto valve stem.
Control knob
Control knob bezel
Install bezel with “OFF” at top.
Sideburner
valve bracket
Screws and Washers
removed from valve bracket
Valve stem
#8-32x3/8” screw
4mm
lock washer
Sideburner
fascia
Note: Use left and right
holes on fascia to
attach valve bracket
Note: Use upper and lower
holes on fascia to
attach bezel
10
11 Insert sideburner burner into left shelf, making sure burner tube engages sideburner valve
(A). Center stud on bottom of
burner fits into center hole in sideburner drip pan. See
illustration C for proper burner-to-valve engagement. Secure burner
to drip pan using two #10-24x3/8” screws, 5mm lock washers, and 5mm flat washers. Attach long sideburner ignitor wire to
sideburner electrode through the slot show
(B).
A
B
Sideburner burner
#10-24x3/8”
screw
5mm lock
washer
5mm flat
washer
Sideburner
ignitor wire
Electrode
C
Burner tube
Valv
e
Air shutter
463248708 • 19