beautypg.com

Batteries, Mains, 1 + riirp – Philips AZ 1402 User Manual

Page 5: J+ ¡1+ 1

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

POWER SUPPLY

Batteries

For the set (optional):

Open the battery compartment of the set and insert six batteries,

type

R20, UM1

or

D-cells

(preferably alkaline).

Remove the batteries if they are flat or the set is not going to be

used for a long time.

Batteries contain chemical substances, so they should be

disposed of properly.

^........

1 +

riirp

■,±

______

_

j+ ¡1+ 1 ]

Mains

1

Check whether the mains voltage as shown on the type plate

corresponds to your local mains voltage. If it does not, consult

your dealer or service organisation.

The type plate is iocated

on the base of the set

If the set is equipped with a VOLTAGE selector (x), set this

selector to the local mains voltage.

2 Connect the mains cable to the AC MAINS inlet and the wall

socket. This switches on the mains supply.

The mains cabie is

inside the battery compartment

The battery supply will be switched off when the set is connected

to the mains. To change over to battery supply, pull out the plug

from the unit's AC MAINS socket.

To disconnect the set from the mains completely, remove the mains

plug from the wall socket.

For users in the U.K.: please follow the instructions on page 2.

To avoid overheating of the set a safety circuit has been built in. Therefore your

set may switch off under extreme conditions. If this happens, release the

POWER button and let the set cool down before reusing it.

This manual is related to the following products: