Philips AZ 1402 - Manual (Page 15)

TROUBLESHOOTING
WARNING
If a fault occurs, first check the points listed
below before taking the set for repair.
Under no circumstances should you try |f
ygy gi-g
unable to remedy a problem by
to repair the set yourself, as this will following these hints, consult your dealer or
invalidate the guarantee. service center.
PROBLEM POSSIBLE CAUSE REMEDY
No sound/no power VOLUME is not adjusted Adjust the VOLUME
Headphone is connected Disconnect headphone
Mains cable is not securely connected Connect the mains cable properly
Batteries are flat Replace batteries
Batteries are incorrectly inserted Insert the batteries correctly
Changing over from mains to battery
supply without removing the plug
Pull out the mains plug from the
unit's AC MAINS inlet
No reaction to
operation of any keys Electrostatic discharge Disconnect the set from power supply
reconnect it after a few seconds
Poor radio reception Weak radio aerial signal Aim the aerial for optimum reception:
- FM: incline and rotate telescopic
antenna
- MW/LW: rotate the entire set
Interference caused by the vicinity of
electrical equipment like TVs, video
recorders, computers, engines, etc.
Keep the radio away from electrical
equipment
n o d t S C or The CD is badly scratched or dirty Replace or clean the CD, see maintenance
E r r o r
indication No CD is inserted Insert a CD
The CD is inserted upside down Insert a CD with label upwards
The laser lens is steamed up Wait until the lens has cleared
The CD skips tracks The CD is damaged or dirty Replace or clean the CD
SHUFFLE or PROGRArvt is active Switch off shuffle or program play
Poor cassette sound
quality Dust and dirt on the heads, capstan
or pressure roller
Clean the heads, capstan and pressure
roller, see MAINTENANCE
Use of unsuitable cassette types
(METAL or CHROME)
Only use NORMAL cassettes for
recording
Recording does not
work
Cassette tab(s) may be snapped off Apply a piece of adhesive tape over
the missing tab space
15