Philips AZ 1402 - Manual (Page 14)

GENERAL INFORMATION
m
3
U3
General maintenance
Do not expose the set, batteries, CDs or tapes to humidity,
rain, sand or excessive heat (caused by heating equipment or direct
sunlight).
The mechanical parts of the set contain self-lubricating bearings
and must not be oiled or lubricated!
You can clean the set with a soft, slightly dampened chamois cloth.
Do not use any cleaning agents as they may have a corrosive
effect.
Tape deck maintenance
To ensure proper recording and playback quality, clean the parts
®dXc) after approx. 50 hours of operation. Use a cotton bud
slightly moistened with alcohol or a special head-cleaner fluid.
Press PLAY ► and clean the rubber pressure rollers ©.
Press PAUSE II and clean the capstans ® and the heads ( a ).
Note: Cleaning of the heads ® can also be done by playing a
cleaning tape once.
CD player and CD handling
The lens may cloud over when the set is suddenly moved from
cold to warm surroundings. Playing a CD is not possible at such
times. Leave the CD player in a warm environment until the
moisture evaporates.
To take the CD out of its box easily, press the centre spindle while
lifting the CD.
Always pick up the CD by the edge and put it back in its box
after use.
To clean the CD, wipe it in a straight line from the center toward
the edge using a soft, lint-free cloth. A cleaning agent may
damage the disc!
Never write on a CD or attach a sticker to it.
This set complies with the radio interference requirements of the
European Community
14