beautypg.com

Controls - figs. 1-2, Supply, Connections – Philips AW 7694 User Manual

Page 3: Radio reception, English

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

English

For the illustrations, keep page 28 open

CONTROLS - figs. 1-2

- О VOLUME control

© POWER on/off switch
© DUBBING SPEED selector
© FM MONO/STEREO selector
® PHONES socket for stereo headphones
© built-in mono microphone MIC

© GRAPHIC EQUAUZER tone controls

100 Hz - lower bass

300 Hz - upper bass

I kHz (1 000 Hz) - mid-range

4 kHz (4 000 Hz) - lower treble

10 kHz (10 000 Hz) - upper treble

® BAND selector
© DBB button - press to increase the bass

response

® SURROUND SOUND button - press ^ to obtain

a surround sound effect

® MODE selector - to select the sound source for

reproduction or recording

© POWER on indicator
© deck A keyboard, for playback only

11 PAUSE

^PLAY

<< F.FWD - fast forward wnd

REWIND - fast rewind

A5 CONTINUE - continuous play (estafette)

Ш STOP/EJECT

© high speed DUBBING indicator
© deck В keyboard, recording and playback

II PAUSE

^ F.FWD - fast forward wind

REWIND - fast rewind

• RECORD - record
Ш STOP/EJECT

© FM STEREO indicator
® TUNING knob

© LINE IN sockets for recording from an amplifier,

receiver, recorder, CD player, etc.

© MAINS - socket for mains lead
© VOLTAGE selector (not on all versions)

The type plate is located on the base of the set.

SUPPLY

Battery supply

• Open the battery compartment (fig. 2) and insert

as indicated eight batteries, type R20, UM1 or
D-cells.

• Remove the batteries if exhausted or if they will not

be used again for a long period.

• The battery supply is switched off if the mains lead

socket MAINS © is occupied. To change over to

battery supply, pull out the plug from the MAINS

socket ©

Mains supply

• Check if the mains voltage as shown on the type

plate corresponds to your local mains supply. If it
does not, consult your dealer or service organisa-
fon.

If the set is equipped with a VOLTAGE selector!^, set

this selector to the local mains voltage.

• Connect the mains lead to the MAINS socket ©

and the wall socket. The mains supply is now

switched on.
• To disconnect the set from the mains completely,

withdraw the mains plug from the wall socket.

Important note for users In U.K.:

When fitl'ng a mains plug to the mains lead proceed as follows:

The wres in the mains lead are coloured in accordance vwth the

following code; Blue = Neutral, Brown=Live.

These colours may not correspondwiih the colourmarkings identifying
the terminals in your plug, so proceed as follows:

Connect the Brown wire to the terminal marked LConnect the Blue wire to the terminal marked N or coloured Black.
No connection is necessary to the earth terminal.

Note: This apparatus must be protected by a 3 Amp Fuse if a 13 Amp

plug is used or. if any other type of plug is used, by a 5 Amp Fuse either
in the plug or adapter or at the distribution board, if In doubt consult

a qualified electrician.

CONNECTIONS

stereo headphone socket PHONES ©

You may connect stereo headphones with 3.5 mm

plug to socket If} PHONES ©. The loudspeakers are

then muted.

Input sockets LINE IN ©

Cinch-sockets for amplifying or recording the signal
from an amplifier, receiver, tuner, recorder, CD

player, etc.

• Connect the UNE IN sockets © to the output

sockets TAPE OUT, REC OUT or UNE OUT of the
other set.

RADIO RECEPTION

• Switch on the set with POWER switch ©.
• Set the MODE selector © to RADIO.
• Adjust the sound with the controls VOLUME ©,

GRAPHIC EQUAUZER DBB bass button ® and

SURROUND SOUND button ©
• Select the wave band using BAND selector ®.

• Tune to a radio station using TUNING knob ©

(SW and LW not on all versions).

- For FM, pull out the telescopic aerial. To improve

This manual is related to the following products: