Power supply setting, Connections (fig. 1), Fitting a mains plug ¡u.k. only) – Philips CD 608 User Manual
Page 4: Mains fuse holder (not all versions), Rc5 in/out, Out l/r, Installation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

INSTALLATION
POWER SUPPLY SETTING
Check that the type plate on the rear of your
player indicates the correct supply voltage.
If your mains supply voltage is different, con
sult your dealer or our Service Organisation.
Certain versions of this player are equipped
with a voltage selector (2), which enables you
to set the player to the correct mains voltage
yourself. When changing the voltage setting, it
is also necessary to change the mains fuse (1)
to one of the correct rating; T300 mA (slow
blow fuse) for 110/127 V; T125 mA (slow blow
fuse) for 220 V - 230 V/ 230 V - 240 V.
CONNECTIONS (Fig. 1)
FITTING A MAINS PLUG ¡U.K. only)
The wires in the mains lead are coloured in accor
dance with the following code;
Blue - Neutral; Brown - Live.
As the colours of the wires may not correspond
with the terminal identification in your plug, pro
ceed as follows:
• Connect the brown wire to the terminal marked
'L' or coloured brown or red.
• Connect the blue wire to the terminal marked
'N' or coloured blue or black.
Mains fuse holder (not all versions)
See 'Power supply setting'.
Voltage selector (not all versions)
See 'Power supply setting'.
RC5 IN/OUT
For connecting up the equipment when you are
incorporating the player in a PHILIPS HiFi sys
tem with its own remote control system.
For connecting the remote control receiver EIVI
2200, available as an accessory (not available
in the U.K.).
DIG(ital) OUT
For digital signal processing or future applica
tions such as CD-I. This output supplies a digital
signal and can therefore only be connected to
an input which is suitable for this signal.
Afeirer connect this socket to a non-digital input
of an amplifier, such as AUX, CD, TAPE,
PHONO, etc!
OUT L/R
For the connecting cable to the amplifier.
Insert a red plug into the 'R' socket and the
other plug into the 'L' socket.
Insert the two other plugs into the correspon
ding sockets of the CD or AUX input of your
amplifier. You can also use the TUNER or TAPE
IN connection, but neverthe PHONO input!
Connection for the mains lead
No connection
should be made to the earth
terminal of the plug!
For 13 A plugs, conforming to BS1363, use a 3
A fuse.
For other plugs, use a 5 A or lower fuse in the
plug, adaptor or at the distribution board.
This Compact Disc player complies with ra
dio interference requirements as laid down
In EC regulations.
I/