Philips PCA460RW User Manual
Cdrw400
Table of contents
Document Outline
- IlllllinillllllllllllllllUllllli
- LASER SAFETY
- CLASS 1
- LASER PRODUCT
- CAUTION
- CAUTION
- FOR EUROPE
- Table of Contents
- Introduction
- Recording Modes
- Chapter 1.
- System Configuration
- Chapter 2.
- Installing your Philips CD Rewriter Drive
- Rear Panel
- Setting your Philips CD Rewriter as the MASTER
- Setting the Philips CD Rewriter as the SLAVE
- CSEL (Cable SELect)
- Installing your Philips CD Rewriter drive
- 1. Switch off your computer, and unplug it from the mains power outlet.
- 2. Remove the cover from your computer.
- 3. Your hands or body may be holding a charge of static electricity.
- 4. Remove the front cover of a vacant half-height drive bay.
- 5. Slide your Philips CD Rewriter into the drive bay from the front.
- 6. Connect the IDE interface connector.
- Connect the AUDIO cable.
- AUDIO cable
- 8. Connect the power supply cable.
- 9. Tighten the four fastening screws securely.
- 10. Re-attach the cover to the computer.
- 11. Connect the power cable to an AC outlet, and switch on your computer.
- 12. Start up your operating system.
- 13. Install your Philips CD recording software
- Chapter 3. Operation
- Front Panel
- 1 Disc tray
- 2 Headphone jack
- 3 Headphone volume control wheel
- 6 Eject button
- 7 Manual Eject port
- Loading a Disc
- Ejecting the Disc
- If your Philips CD Rewriter is powered-up:
- If your Philips CD Rewriter is not powered up:
- Manual Eject (emergency use)
- 1. Insert the pin-like tool into the manual eject port and push gently.
- After manually ejecting a disc, you must turn off the power supply to your Philips CD Rewriter, then turn it back on before continuing.
- Troubleshooting
- Appendix