Setting your philips cd rewriter as the master, Setting the philips cd rewriter as the slave, Csel (cable select) – Philips PCA460RW User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Setting your Philips CD Rewriter as the MASTER

As shown in the diagram at the right, insert the jumper pin into

the right edge of the jumper switch.

Note;

If only your Philips CD Rewriter luill be connected to

the IDE interface connector, connect the Philips CD

Rewriter to the end of the connector.

Setting the Philips CD Rewriter as the SLAVE

As shown in the diagram at the right, insert the jumper pin into

the middle of the jumper switch.

3 OUT

CSEL

I—

SLAVE

j- MASTER

3 OUT

CSEL

t—SLAVE

j- MASTER

CSEL (Cable SELect)

If you choose the CSEL setting, the MASTER/SLAVE setting will be made automatically
depending on your hardware configuration. For details refer to the user manual of your
computer.

8 {>hl>ips CD Rewriter