Chapter 1, System configuration, Computer – Philips PCA460RW User Manual
Page 7: Software, Tools, Long nose pliers, Computer software tools, Chapter 1. system configuration
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Chapter 1.
System Configuration
Before using your Philips CD Rewriter, make sure that you have all of the items on the list of
included items.
In order to use your Philips CD Rewriter, you will require the following.
Computer
The following operating environment is required:
•
An IBM/AT compatible computer with a 100 MHz or faster Pentium CPU, or a 100
MHz or faster 486 CPU
•
A vacant IDE interface connector
•
A vacant half-height bay
•
Windows 98, Windows 95, Windows NT4.0 or Higher
•
Sufficient hard disk space
Note:
You will need about twice as much space on your hard disk as that required by the data
you wish to write to CD
Software
The Philips CD-RW software packed with your Philips CD Rewriter has been carefully
designed to give you the best possible results with the maximum ease of use.
Tools
Cruciform screwdriver
This is used to remove the cover of your computer,
and to install your Philips CD Rewriter drive.
Cruciform Screwdriver
Long nose pliers
These are used to insert or remove the jumper pin
when setting the MASTER/SLAVE settings of your
Philips CD Rewriter drive.
Long nose pliers
Chapter 1 - System Configuration S