Cisco 12012 - Manual (Page 19)

Cisco 12012 Gigabit Switch Router Card Cage Assembly Replacement Instructions 19
Removing and Replacing a Card Cage Assembly
Step 4 Select one of the cards in the lower card cage to remove. Grasp the two card ejector levers
and simultaneously pivot both ejector levers ninety degrees inward (away from the sides
of the card cage) to unseat the card from the backplane connector. (Refer to Figure 11.)
Figure 11 Removing Cards From the Lower Card Cage
Step 5 Touching only the metal card carrier, slide the card out of the slot and place it immediately
on the antistatic mat.
Repeat Step 4 and Step 5 for the rest of the cards in the lower card cage.
GIGABIT R
O UTE PR
OCESSOR
Q OC-3/STM-POS OC-12/STM-4 A
T M
OC-12/STM-4 POS
ALARM
CS C
0
FAIL
1
0
1
2
EN AB LE D
SFC
H10474
Lower card
cage
Switch fabric
card
Card ejector lever Card ejector lever