Philips FW45C - Manual (Page 24)

CLOCK TIMER
View Clock
You can view the clock (if it is set) at standby or any source
mode. It will be displayed for about 7 seconds.
• Press CLOCK-TIMER briefly.
— " /£?.■,?5 PM" (the current time) will be displayed.
—
will be displayed if the clock is not set.
Clock Setting
The clock is set in 12-hour mode, e.g." ic':00 AM" or
" !c'- uu PM". Before setting the clock, you must be in
the View Clock mode.
1 Press CLOCK-TIMER to select clock mode.
" i c ' D D AM" or the current time starts flashing.
2 Set the hour with ◄◄ or
3 Set the minute with N or ►!.
4 Press CLOCK-TIMER again to store the setting.
The clock starts running.
- To exit without storing the setting, press ■.
Notes:
- During clock setting, if no button is pressed within 90
seconds, the system will exit clock setting mode
automatically.
- When a power interruption occurs, the clock setting is
erased.
Timer Setting
- The system can switch on to CD or TUNER mode
automatically at a preset time. It can serve as an alarm
to wake you up. After half an hour from the preset time,
the system will return to the standby mode if no button
is pressed.
- Before setting the timer, make sure the clock is set
correctly.
- The timer has to be reset or start again for each
subsequent preset time.
- The volume of the timer will be at the last setting
before the set is switched to standby mode.
1 Press and hold CLOCK-TIMER for more than 2 seconds
to select timer mode.
— "ON /-/'•'¿7¿7 AM" or the last set timer starts
flashing. The TIMER flag flashes.
The last selected source is lighted while other
available sources are flashing.
2 Press CD or TUNER to select the desired source.
3 Press or ►► to set the hour for the timer to start.
4 Press N or H to set the minute for the timer to start.
5 Press CLOCK-TIMER to store the start time.
— The TIMER is now set.
-* The TIMER flag remains on the display.
- To exit without storing the setting, press ■ .
24