Demonstration mode, To cancel demonstration mode, Easy set – Philips FW45C User Manual
Page 14: Switching the system on, Tuner, tape oraux, Switching the system to standby mode
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
UrCIfAlirail inUdYMEM
Important:
Before you begin operating the system, complete the
preparation procedures.
Demonstration mode
The system has a demonstration mode that shows the
various features offered by the system. Whenever the
system is switched on from the wall socket, the
demonstration mode will start automatically.
Notes:
- During demonstration mode, if you press any source (or
standby-on) button, the system will switch to the
respective (or standby) mode.
- When the system is switched to standby mode, 5
seconds later, the demonstration mode will resume.
To cancel demonstration mode
• Press and hold STOP-CLEAR ■ (DEMO) (on the
system only) for 3 seconds to stop the demonstration.
The demonstration mode will be switched off.
The system will switch to standby mode.
1
Easy Set
EASY SET allows you to store all available radio stations in
a particular band (EM or AM) automatically.
• Press and hold STANDBY»ON (on the system only) for
2 seconds; when the system is in standby or
demonstration mode.
"CRGEI GCT" will be displayed and followed by
"Ti iriD"
I Ul v t L I '
.
EASY SET will start with the last active band.
— All available radio stations with sufficient signal
strength will be stored or until 40 presets are filled.
Notes:
- When EASY SET is used, all previously stored stations
will be erased.
- The last preset station will appear on the display when
EASY SET is completed.
Switching the system ON
• Press STANDBY*ON (on the system only), CD,
TUNER, TAPE orAUX.
You can also switch on the system by pressing any one of
the CD DIRECT PLAY buttons.
Switching the system to standby mode
• Press STANDBY'ON again.
-* Tbe system will switch to standby mode.
14