Philips PR 0920X - Manual (Page 2)

H ooking
U
p Y our
TV (A ntenna /C able C onnections )
A ntenna |—CBEGIN>
■
CoMBiN V I ION I HFA HF
A combination antenna
or a rod antenna (sup­
plied) receives normal
broadcast channels (VHF
2-13 and UHF 14-69).
Your connection is easy
since there is only one
75Q (ohm) ANT(enna)
plug on the back of your
TV - and that’s where the
antenna goes.
If you install a rod
antenna (supplied), push the
stem of the antenna into the
antenna hole on either the right
or the bottom of the TV.
If your antenna has a round
cable (75 ohm) on the end,
then you’re ready to connect it
to the TV.
K your antenna has flat twin-
lead wire (300 ohm), you first
need to attach the antenna wires
to the screws on a 300 to 75
ohm adapter.
Push the round end of the
round cable of the rod antenna,
adapter, or cable onto the
ANT(enna) plug on the rear of
the TV. If the round end of the
adapter or cable is threaded,
screw it down tight.
If you installed a rod
antenna, extend the antenna
and adjust its length, direction,
and angle for the clearest pic­
ture.
Combination
VHF/UHF
Antenna
(Outdoor or
Indoor)
Round Cable
75Q
BDHQ
b
' Remember, g *
be sure to set the
TV for the type sig­
nal you've connect­
ed (see page 4).
To set the TV to
select only the
channel numbers in
your area, see
“Channel Auto
Memo” on page 4.
If you install the
TV beneath a
kitchen cabinet, you
may push a rod
antenna into the
antenna hole on the
bottom of the TV
(see page 3).
■ 2 -