Philips XS1956CI - Manual (Page 5)

H ooking
U
p
Y
our
TV (B asic C able
TV C onnections )
C able TV
o
y our Cable TV input into your
home may be a single (75
ohm) cabley or a Converter Box
installation. In either case the
connection to the TV is very easy.
Just put the threaded end of the
cable signal to the TV's antenna
plug and screw it down tight,
(jBEIgiN)
If your Cable TV signal is a sin­
gle round cable (75 ohm) then
you're ready to connect to the TV.
If you have a Cable Converter
Box:
Connect the Cable TV signal to the
Cable Signal IN(put) plug on the
Converter..
Connect the Cable TV cable to the
75Q plug on the TV.
If you have a Cable Converter Box:
Connect the OUT(put) plug from the
Converter to the 75Qplug on the TV.
Remember: ■
Set the TV for the
type signal you've
just connected (see
the “Tuner” section
on page 11 of this
manual.)
To select only the
channel numbers on
your Cable system
see “Auto Program"
(page 12). If you use
a Cable Converter
box, set the TV to the
same channel as the
converter's CH 3/4
switch (on the rear of
the converter.)
Cable TV Converter
Box Connection