Coway BA08-AR - Manual (Page 24)

24
Installation the Remote Control Mount
5 . insert the rotating axis in the opposite side after
pulling out it from the remote control mount .
 Insert the axis with the thicker part facing the
back of the remote control mount.
6 . insert the cover-axis in the hole on the opposite side
of the rotating axis .
 Align two projections with the two grooves on the axis when
inserting the cover-axis.
7 . Fix the rotation axis and the cover-axis with a screw .
Please tighten the cover-axis firmly. If the screw is loosely
assembled, the remote control mount may be separated and is
dropped, which may cause product damage or a bodily injury.
8 . Please separate the rubber stopper from the opposite
side of the bidet installed the remote control mount
before .
 Please be sure to insert the separated rubber stopper to the
opposite remote control mount fixing groove. Otherwise, the
product may break.
9 . insert the rotation axis of the remote control mount
and fix the remote control mount with the fixing
screw (Ø 6) on the bidet bottom .
Please tighten the fixing screw (Ø 6) firmly. If the screw is loosely
assembled, the remote control mount may be separated and is
dropped, which may cause product damage or a bodily injury.
INSTALLATION
1021214 BA08-A 사용설명서_미주향_(09.06.10)_003.indd 24 2009.6.10 6:17:2 PM