Interlogix NX-148E User Manual

Page 13

NX-148E LCD Keypad

VIEW ZONE STATUS

Step 1 Press

r • . The LCD Screen will display the zone status.

Step 2 Use the up and down scroll keys to browse through the descriptions. The LCD

Screen will display the list of all zones in sequential order by zone number.

Step 3 Press [#] to exit this function.

SETTING THE KEYPAD TONE

Step 1 Press

r 0 . Keypad is now in the “Adjust Tone” mode.

Step 2 Press the

• up scroll key located on

the right side of the display to adjust
the keypad sounder to higher tones.

Step 3 Press the

– down scroll key to adjust

the keypad sounder to lower tones.

Step 4 When the desired tone is reached, press # to set this tone and exit from the

“Adjust Tone” mode.

VIEW ALARM MEMORY

Step 1 Press

r 3 to display the zone(s) on the keypad that created the last

alarm.

Step 2 The LCD Screen will display the zone

description for those zones.

Step 3 Press [#] to exit the alarm memory.

TEST FUNCTION (Optional, if programmed)

If programmed, this function will perform a battery test, communicator test, and/or a
siren test. No alarms will be sent, and no reports will be sent unless a communicator
test is performed, in which case a test signal will be sent.

Step 1 Press

r 4 4 . The test will be performed as programmed.

Step 2 If the siren test is performed, enter a user code to silence the siren.

Raise tone

Lower tone º

arm Memory 1

ZONE 1