Interlogix NX-148E User Manual

Page 11

NX-148E LCD Keypad

If you do not know the number of the zone you wish to bypass,
use the following steps:

Step 1

Press

r • The description for zone 1 will be displayed.

Step 2

Use the

• – scroll keys to browse through the custom descriptions for

the zones in this system.

Step 3

To bypass or unbypass a specific zone, press the [BYPASS] key while that
zone is displayed.

Step 4

When finished, press the # key to return to the code entry screen.

GROUP BYPASS

By pressing the [BYPASS] key, followed by the 0 key, then the [BYPASS] key again,
all zones that are designated as group bypass zones will be bypassed. Press the
[BYPASS] key again to exit group bypassing.

UNBYPASSING

To manually unbypass zones, perform the bypassing procedure on a zone that is
already bypassed. NOTE: All zones will automatically be unbypassed each time the
system is disarmed.

EMERGENCY ACTIVATION KEYS

NOTE: You must press and hold these keys for 2 seconds to activate these
functions. Your system may not be programmed for these activations.

Fire Key - If programmed, you can activate the Fire alarm by pressing the Emergency
Activation [Fire] key for two seconds. If your system is connected to a monitoring
center, an emergency report could be sent to that center. This key should only be
pressed in an emergency situation requiring response by fire department personnel.

Procedure #2