Interlogix UVD-6130VE-2 User Manual - Manual (Page 17)

UltraView UVD-6130VE-2 WDR Dome Camera User Manual 15
Mode: Enable or disable the selected mask.
Position: Press Enter to get the submenu to set position the mask on screen.
values.
Color: Select the color of the privacy mask: White, Red, Black, Green, Blue,
Yellow, Cyan or Magenta.
Transp: Select the transparency shade of the privacy mask. The privacy mask is
fully transparent at value 0.00 and not transparent at 1.00.
Mosaic: Enable this option to see the mask as a mosaic. It is disabled by default.
Note: Only four privacy mask areas can be set when motion detection is
enabled.
Set motion detection
In the Setup menu, select Motion Det to open the motion detection menu.
Use this function to identify when a moving object passes in front of the camera
to activate an alarm. Up to four motion detection areas can be configured, each
by size and location on-screen.
Detect sense: Set the sensitivity level for motion detection. A higher value is
more sensitive.
Block Disp: When enabled, any movement detected will be tracked on-screen.
Press
Enter to enable or press the button again to cancel it. The default setting is
Off (no motion detection).
Detect Area: Up to four motion-sensitive areas can be set. Set the size and
position of each one.
Monitor area: Enable a square grid to be displayed on-screen and set its
position. It can only be set if Block Disp is enabled.
Display the synchronization mode
In the second Setup menu, go to Sync to open the synchronization menu.
Use the Sync menu to display the current synchronization mode. Only one
option is available: Internal.