Cisco 7100 Series - Manual (Page 14)

12
Connect the Router to the Network
(continued)
Connect the Console Port
Use the console terminal for local administrative access to the router.
1 Attach the appropriate cable (RJ-45 rollover cable and an RJ-45-to-DB-25 or
RJ-45-to-DB-9 adapter) directly to the receptacle on the router. The adapters provided are
labeled TERMINAL. Other types of adapters are not included.
2 Attach the other end of the cable to a terminal or PC.
3 Configure the terminal or PC terminal emulation software for 9600 baud, 8 data bits, no
parity, and 2 stop bits.
Note: Refer to the “Connecting the Console Port and Auxiliary Port” section in Chapter 3,
“Installing Cisco 7100 Series Routers,” in the Cisco 7100 Series VPN Router Installation and
Configuration Guide.
AC OK DC OK OTF
AC OK DC OK OTF
RX
TX E3 RX
5
TX E3 RX EN
CEL CAR ALM
I
CONS
FE 0 / 0 FE
ACT
0 / 1 AUX
0
2
7140 - 2AE3 100-240Vac 50/60Hz 5-2.5A 525W
RX EN
CEL CAR ALM
ACT
LNK 0 LNK 1
PWR
SYS
RDY
SLOT 0 SLOT 1
22069
Cisco 7100 series router
Console port
(RJ-45)
RJ-45-to-RJ-45
rollover cable
PC (laptop)
RJ-45-to-DB-9 or
RJ-45-to-DB-25 adapter
(labeled TERMINAL)