Connect the router to the network (continued), Connect the atm smi3 and mm3 ports, Warning – Cisco 7100 Series User Manual
Page 13
11
Connect the Router to the Network
(continued)
5
I
155 - MM
RX
RX
EN
CEL CAR ALM
TX
22129
To ATM network
equipment
ATM 1/0
Connect the ATM SMI3 and
MM3 Ports
The SMI3 (OC-3c/STM-1 single-mode
intermediate reach) and MM3
(OC-3c/STM-1 multimode) ports provide
an interface to ATM networks and transmit
and receive data at rates of up to 155 Mbps
bidirectionally. The SMI3 and MM3 ports
connect to a SONET/SDH single-mode or
multimode optical fiber cable. Use one
duplex SC-type connector or two simplex
SC-type connectors.
Warning
Class 1 laser product.
Warning
Because invisible laser
radiation may be emitted from the
aperature of the port when no fiber
cable is connected, avoid exposure
to laser radiation and do not stare
into open apertures.
1
Attach the fiber-optic cable (either one
duplex SC-type connector or two
simplex SC-type connectors) directly to
the receptacle on the router.
2
Attach the network end of the cable to
an external DSU (an ATM network).
Note: For information on SONET
specifications for fiber-optic transmissions,
power budget, and power margins for
multimode and single-mode transmissions,
refer to Appendix C, “Cable Specifications,”
in the Cisco 7100 Series VPN Router
Installation and Configuration Guide.