Connect the router to the network (continued), Connect the atm t3 or e3 ports – Cisco 7100 Series User Manual
Page 12

10
Connect the Router to the Network
(continued)
22127
To ATM T3 network
equipment
Serial 1/0
5
I
RX
TX
DS3
RX
EN
CEL CAR ALM
Connect the ATM T3 or E3
Ports
The T3 port supports full-duplex operation
at T3 (45-Mbps) speeds. The E3 port
supports full-duplex operation at E3
(34-Mbps) speeds. Use a 75-ohm coaxial
cable to connect to a T3 or E3 ATM serial
network. Serial cables conform to
EIA/TIA-612 and EIA/TIA-613
specifications. The T3 and E3 serial ports on
the router are considered to be DTE devices.
1
Attach a 75-ohm coaxial cable directly
to the receptacle on the router.
2
Attach the network end of the cable to
the external synchronous serial
equipment.
Note: The E3 coaxial cable (not shown)
comes with an attached ferrite bead.
See also other documents in the category Cisco Hardware:
- ASA 5505 (1994 pages)
- OL-15491-01 (268 pages)
- WUSB600N (43 pages)
- 10000 (556 pages)
- 10000 (12 pages)
- 3825 (358 pages)
- WRV54G (101 pages)
- WUSB54GC (33 pages)
- 2600 Series (10 pages)
- DPQ2202 (38 pages)
- 1600 (13 pages)
- WRT320N (53 pages)
- 1701 (10 pages)
- 300 (16 pages)
- 3200 Series (60 pages)
- 2900 SERIES XL (138 pages)
- 4430 (12 pages)
- 1005 (6 pages)
- 3500 Series (8 pages)
- GigaStack WS-X3500-XL (58 pages)
- WIRELESS-G WRT54GP2 (112 pages)
- 1604 (22 pages)
- 3600 Series (18 pages)
- WIRELESS LAN CONTROLLER OL-17037-01 (80 pages)
- DPC3000 (36 pages)
- 3545 MCU (56 pages)
- WRT110 (48 pages)
- 7300-6T3 (54 pages)
- 10BASE-FL (40 pages)
- 340 (62 pages)
- 1700 (88 pages)
- 1700 (14 pages)
- 12000 (60 pages)
- 3600 (18 pages)
- 1800 Series (12 pages)
- 2000 (6 pages)
- ACE XML OL-13877-01 (12 pages)
- 10720 (26 pages)
- 10008 (48 pages)
- 10008 (38 pages)
- 1-PORT G.SHDSL 2600 (22 pages)
- XM Universal Gateways Cisco AS5400XM (100 pages)
- 1710 (12 pages)
- WRTP54G (114 pages)
- 7201 (4 pages)