Interlogix TVC-6120-1 User Manual - Manual (Page 15)

TruVision TVC-6110-1 / TVC-6120-1 Camera User Manual 13
Set Day/Night mode
In the Setup menu, go to Day/Night and select the desired mode. The Day/Night
mode has two options: Auto, Color and B/W.
Select Color to manually set the camera to color (day) mode.
Select Auto so that the camera can automatically switch between day (color) and
night (black and white) mode.
Auto mode:
Burst: Enable/disable the color burst component of the video signal when the
camera switches to B/W. ON mode maintains the same color signal in B/W so
that the video signal provides better compatibility with certain color equipment.
OFF mode removes the color burst signal B/W video and increase the total TV
lines.
Delay CNT: This is the time in seconds
before Day↔Night switches. A long
delay response would be used, for example, to avoid switching from Night to Day
mode when car headlights pass in front of the camera.
Day→Night: Set the threshold level on how dark it should be before switching
from Day to Night mode. Lower (Higher) value makes the camera switched from
Day to Night at lower (higher) illumination
Night→Day: Set the threshold level on how light it should be before switching
from Night to Day mode.
Caution
: If there is a minimal difference between the Day→Night and
Night→Day values, then camera may switch between Day and Night mode
repeatedly.
Set image noise reduction
In the Setup menu, go to NR and select the desired mode. Set the noise
reduction strength of the luminance signal (Y).