Interlogix NX-4V2 User Manual - Manual (Page 15)

NX-4V2 LED Keypad User Manual 11
Assigning user code authority levels
Assign authority levels to users by following the steps below. Assign user codes
before assigning authority levels. Your system must be in the disarmed state to
change user code authority levels.
1. Press [*]-[6].
2. Enter a “Master Arm/Disarm Code”.
3. The ready light will flash.
4. Enter the 2-digit user number. Always use leading zeros when necessary, i.e.
"004" for user number 4.
5. Lights illuminated indicate the authority levels assigned to this code. An
explanation of the lights is listed below. You may toggle (turn on/off) the
authority level by pressing the number for that authority level (see Table 3
below).
Table 3: Authority levels
Ligh
t Authority level if light 8 is off
1 Reserved (Note: Do not change if on.)
2 Arm Only
3 Arm Only After Close Window
4 Master Arm/Disarm (can program other codes)
5 Arm/Disarm
6 Bypass Zones
7 Open / Close Reporting
8 If this light is on, the code is programmed as a function code. Do not change, Press [#] - [#]
to exit.
6. Press [
∗
][
∗
]. This returns you to Step 3 previously mentioned. At this point
you may enter another user number to assign authority level. Repeat Steps 4
- 6 until you have assigned authority levels to all user numbers.
7. Press the [#] key to exit the Assigning Authority Level Program.
Other keypad functions
Setting the keypad tone
1. Press [
∗
]-[0
]. Keypad is now in the “Adjust Tone” mode.