Interlogix POE302-MS - Manual (Page 11)

IFS POE302-MS Ethernet Injector User Manual 5
Injector and Splitter Installation
1. Connect the external power adaptor to the 56 VDC power
connector of the POE302-MS. The power LED will be lit.
2. Connect a standard network cable from the “Ethernet+DC”
port of the POE302-MS to the “PoE In” port of the POE302-
SP. The POE In-use LED of POE302-MS / POE302-SP will
remain lit showing operation.
3. Connect a standard network cable from the non-PoE
switch or other network device to the “Ethernet” port of
POE302-MS.
4. Select either 12VDC or 24VDC on the DC power output
switch and then connect the DC plug from "DC Out" of the
POE302-SP to the remote device.
5. Adjust proper DC power output and connect DC plug from
"DC OUT" of POE302-SP to remote device.
6. Power on the remote device and its power LED indicator
will remains on. Remote device will be powered upon
completion of the previous steps.
Figure 3: Injector and Splitter connection
Note: According to the IEEE 802.3at Power over Ethernet
standard the POE302-MS will not inject power to the cable if it
is not connected to IEEE 802.3at devices.