Interlogix SP-PoE - Manual (Page 6)

Installation
To connect the hardware, do the following:
1. Connect a standard network cable from "Ethernet+DC" of MS-POE to
Ethernet+DC" of SP-PoE. The POE LED of SP-PoE/MS-POE will start to
flash continuously.
Figure 3 MS-PoE/SP-PoE application
100Base-TX UTP
100Base-TX UTP with PoE
Power line (DC)
1. Switch
2. Power
3. Data
4. Wireless access point
Note: The SP-PoE only accepts IEEE 802.3af equipment. Other in-line power
devices may cause the SP-PoE to malfunction.
2. Connect the UTP cable in the package from "Ethernet" of SP-PoE to the RJ-
45 port of the remote device.
3. Connect the correct DC plug from "DC OUT" of SP-PoE to the remote device.
Caution: Please ensure the output voltage is correct for remote device.
Otherwise it will damage your remote device.
4. Power on the remote device and the LED indicator on SP-PoE will remains
on.
Connect with other 802.3af devices
The SP-PoE also provides an alternative way to connect to non IEEE 802.3af
devices and to connect with an IEEE 802.3af in-line power device like a Power
over Ethernet Switch. See the figure below.
6 SP-PoE Splitter User Manual