Interlogix GE-DSSG-244-POE Installation Guide - Manual (Page 7)

IFS NS2503-24P/2C Quick Guide
7
Figure 4: Show IP information Screenshot
 Configure IP address
1. On “Switch(config)# ” prompt, enter the following command and press . As show in Figure 5.
Switch(config)# ip address 192.168.1.100 255.255.255.0
Switch(config)# ip default-gateway 192.168.1.254
The previous command would apply the follow settings for the Switch.
IP: 192.168.1.100
Subnet Mask: 255.255.255.0
Gateway: 192.168.1.254
Figure 5: Set IP address Screenshot
2. Repeat Step 1 to check if the IP address is changed.
If the IP is successfully configured, the Managed Switch will apply the new IP address settings immediately. You can access the
Web interface of FGSD Managed Switch through the new IP address.