Interlogix GE-DSSG-244-POE Installation Guide - Manual (Page 10)

IFS NS2503-24P/2C Quick Guide
10
1. We recommend using Internet Explore 6.0 or above to access Managed Switch.
2. If the IP address of the switch is changed, the change will take effect immediately after you
have clicked on the Apply button, therefore you need to use the new IP address to access
the Web interface.
3. For security reasons, please change and memorize the new password after the first setup.
4. The Switch accepts commands in lowercase letters on the web interface.
Resetting the IP address and Admin Password
To reset the IP address to the default IP Address “192.168.0.100” or reset the password to default value press the hardware
reset button at the front panel about 10 seconds. After the device is rebooted, you can login the management WEB interface
within the same subnet of 192.168.0.xx.
Contacting Technical Support
Contact technical support if you encounter any difficulties during this installation. Please make
sure you have the requested diagnostic or log files ready before you contact us by phone or go to
www.interlogix.com/customer-support .
Technical Support
Europe, Middle East and Africa
W Select Contact Us at www.utcfssecurityproducts.eu
North America
T +1 855.286.8889
E [email protected]
Australia
E [email protected]
Reset