Interlogix GE-DSSG-244-POE Installation Guide - Manual (Page 6)

IFS NS3601-24P/4S Quick Installation Guide
6
Login in the Console Interface
Once the terminal has connected to the device, turn on the Managed Switch, and the terminal will display the status of testing
being performed.
Then, the following message asks the login user name and password. The factory default user name / password as following
and the login screen in
Figure 3 appears.
Username: admin
Password: admin
Figure 3: Managed Switch Console Login Screenshot
1. For security reasons, please change and memorize the new username and password after
this first setup.
Username Max: 6, Min: 1 characters.
Password Max: 6, Min: 1 characters.
2. Only accept command in lowercase letter under console interface.
Configure IP address
The Managed Switch is shipped with the following default IP address.
IP Address : 192.168.0.100
Subnet Mask : 255.255.255.0
To check the current IP address or modify a new IP address for the Switch, please use the following procedures:
 Show the current IP address
1. On ”Switch# ” prompt, enter “configure”.
2. On ”Switch(config)# ” prompt, enter “show ip”.
3. The screen displays the current IP address, Subnet Mask and Gateway. As show in Figure 4 .