ILY CFast/HDD Duplicator - Manual (Page 7)

SATA HDD Duplicate Controller Manual
3.1 Copy HDD
Copy HDD copies data directly from the source hard disk to the target hard disk. Please make
sure that the capacity of the target hard disk is equal or larger than the source hard disk.
Choose option 1 from the menu:
1. Copy HDD
HDD:11 232.9GB
Press ENT to begin copy. The system will auto-detect the hard disks and show the following
copying info on the LCD.
Copy-36MB/s 0%
232.9GB 00:00:00
The LCD will show the following info during the copying process: elapsed time, completed
percentage. The copy speed, capacity and time will vary depending on the source hard disk. Once
the copying process is complete the LCD will display the following results.
Copy HDD
OK: 11
Fail: 0
3.2 Async Copy HDD
This option allows when the replication process can increase the extra hard disk devices.
Choose option 2 from the menu:
2. Async Copy HDD
HDD:10 232.9GB
Press ENT. Before the start of the reproduction, if the ARS-2061F to detect the eigth hard drive
capacity is less than source, then the LCD will show the corresponding channel number.
8
Space Not Enough
And then automatically copies. The LCD will display the following info.
Acpy-36MB/s 0%
232.9GB 00:00:00
If the replication process to continue to add additional hard disk device, LCD will only show the last
completed percentage.
Once the copying process is complete the LCD will display the following results.
Async Copy HDD
OK: 11 Fail: 0
6