IC Realtime 540TVL 23x High Speed PTZ Camera with 250' IR - Manual (Page 8)

1
1 Features and Functions
1.1 General Introduction
This series IR intelligent speed dome product is an integrated high intelligent speed dome. It adopts
waterproof design and has small and delicate shape. This is a digital and intelligent product of vivid video. It
supports the auto IR light enable function in low illumination environments and the near and far light
intelligent control. The installation is convenient.
This series product can be widely used in remote monitor environments such as electric power, customs,
and water conservancy. It is suitable for the monitor environments of low illuminations such as the village,
town and suburb.
1.2 Features
This series speed dome has the following features:
1.2.1 On-Screen Menu
This series product menu supports multiple languages display and switch.
It is easy for you to view dome information and configure dome, camera parameters.
1.2.2 On-screen Tips
It is the screen operation prompt. Here you can set call preset and display the preset number during the tour.
It can display preset title, system software version, speed dome position coordinates and etc.
1.2.3 Support multiple protocols
This series speed dome supports universally used protocols such as PELCO-P and PELCO-D. You can use
various devices (such as matrix, control keyboard and DVR) and protocols to operate speed dome.)
1.2.4 Proportional Pan and Tilt
This function keeps the image from moving too fast when there is a large amount of zoom.
Speed dome continually decreases or increases pan and tilt speeds in proportion to depth of zoom. When
zooms speed is increasing, the camera moving speed becomes slow. When zooms speed is decreasing, the
camera moving speed becomes fast.
1.2.5 Preset Setup and Recall
Preset function is to save the address information (such as PTZ pan/tilt, focus and etc) to the memory so
that you can quickly adjust the dome and PTZ to the correct position.
1.2.6 Auto
Scan
Camera scans back and forth regularly in a horizontal field. Here you need to set left and right limit and scan
speed.
1.2.7 Auto Touring
Add addresses into a routine in a desired order and then set time and stop duration for each address. The
dome will begin an auto touring between these addresses.