IC Realtime 1080P (Full HD over coax) HD-SDI / HDcctv 20x Optical PTZ / IR - Manual (Page 29)

22
IDLE FUNC ： OFF
IDLE TIME ： 010MIN
IDLE ACTION ：PRESET
PRESET NO ：001
AUTO SCAN NO ：001
CRUISE NO ： 001
PATTERN NO ：001
SAVE
BACK
EXIT
PTZ SPEED ：OFF
SET ZERO
POWER UP
MENU IDLE
PTZ AUTO STOP
HEATER SETTING
SAVE
BACK
EXIT
When there is no available command for specified time, dome automatically goes on the previous set
functions.
• IDLE FUNCTION ： There are two modes ON/OFF. Please use left/right key to set.
• IDLE TIME: System idle period. Please use the left/right button on the keyboard or in the speed
dome terminal menu to set.
• IDLE ACTION：There are several functions you can select:
NONE/PRESET/SCAN/TOURING/PATTERN. Please use the left/right button on the keyboard or in
the speed dome terminal menu to set.
• PRESET NO： Here is for you to set preset number. The value ranges from 1 to 255. System goes
to specified preset when idle status is on.
• AUTO SCAN NO： The value ranges from 1 to 5. Please use the left/right button on the keyboard or
in the speed dome terminal menu to set. System begins specified scan when idle status is on.
• CRUISE NO： The value ranges from 1 to 8. Please use the left/right button on the keyboard or in
the speed dome terminal menu to set. System begins specified touring when idle status is on.
• PATTERN NO：The value ranges from 1 to 5. Please use the left/right button on the keyboard or in
the speed dome terminal menu to set. System begins specified pattern when idle status is on.
• SAVE：Move the cursor to SAVE and click confirm button to save current setup.
• BACK: Go back to previous menu.
• EXIT: Log out system menu.
4.4.4.8 Next Page
Move the cursor to the NEXT PAGE and then click the confirm button, you can go to the third menu to
set the PTZ SPEED, SET ZERO, POWER UP and etc.
• PTZ SPEED: It is to set PTZ speed. Please use the left/right button on the keyboard or in the speed
dome terminal menu to set.
• SET ZERO: It is to set the PTZ initial position. Please move the PTZ to the corresponding position
and then click the confirm button to complete the setup.
• POWER UP: It is to set the dome operation when the speed dome boots up. Click the confirm button
to go to the next interface to set