IC Realtime 1080P (Full HD over coax) HD-SDI / HDcctv 20x Optical PTZ / IR - Manual (Page 12)

5
Please refer to the protocol sheets for detailed information.
Reserved Baud rate Parity 120 Ω Connect to the 120 Ω
1 2 3 4 5 6 7 8 ON
Please note the speed dome cans automatically recognize the industrial protocol, PELCO-D. PELCO-
P. Usually you do not need to set.
Please refer to the baud rate sheet for detailed information.
4 5 Baud Rate
OFF OFF 9600bps
ON OFF 4800bps
OFF ON 2400bps
ON ON 1200bps
Please refer to the parity setup sheet for detailed information.
6 7 Parity
OFF OFF NONE
ON OFF
EVEN
OFF ON ODD
ON ON NONE
2.2 Set address dial switch
SW2
Figure 2-3
The encode mode adopts binary system. 1 to 8 is the valid bit. The highest address bit is 255. You can refer
to the following sheet for more information.
Note:
The broadcast address is 255. When the host device address is 255, you can control all the intelligent
speed domes connected to the host so that you can debug conveniently.
Address 1 2 3 4 5 6 7 8
1 OFF OFF OFF OFF OFF OFF OFF OFF
1 ON OFF OFF OFF OFF OFF OFF OFF
2 OFF ON OFF OFF OFF OFF OFF OFF
3 ON ON OFF OFF OFF OFF OFF OFF