beautypg.com

2 protocol, baud rate, address setup, 1 protocol and baud rate setup – IC Realtime 1080P (Full HD over coax) HD-SDI / HDcctv 20x Optical PTZ / IR User Manual

Page 11

background image

4

2 Protocol, Baud Rate, Address setup

Before you operate, you need to set protocol, baud rate and address. Otherwise you can not control

the product!

2.1 Protocol and Baud Rate Setup

Please configure the following settings before begin controlling dome:
z

Address

z

Baud

rate

z

Parity

Note: Please reboot the speed dome to get all the setups activated!

Open the lower dome, the interface is shown as below. See Figure 2-1.

SW2

SW1

Figure 2-1

SW1

Figure 2-2