HONDA 2015 CR-V - Owner's Manual (Revised 12/15/2014) - Manual (Page 343)

342
Features
Compass
When you turn the ignition switch to ON ( w *1 , the compass self-calibrates, and the
compass display appears.
Compass Calibration
If the compass indicates the wrong direction, or the CAL indicator blinks, you need
to manually calibrate the system.
1. Turn the ignition switch to ON ( w .
2. Press and hold the SETUP button until the
display shows the compass setting menu.
3. Rotate to select Calibration, then press
.
4. When the display changes to Calibration
Start, press .
5. Drive the vehicle slowly in two circles.
u The compass starts to show a direction
after the calibration. The CAL indicator
goes off.
*1: Models with the smart entry system have an ENGINE START/STOP button
instead of an ignition switch.
1 Compass
Compass operation can be affected under the
following conditions:
• Driving near power lines or stations
• Crossing a bridge
• Passing a large vehicle, or driving near a large
object that can cause a magnetic disturbance
• When accessories such as antennas and roof racks
are mounted by magnets
Models with one display
Compass Setting Menu Items
1 Compass Calibration
Calibrate the compass in an open area.
While setting the compass:
• The button returns to the previous screen.
• The SETUP button cancels the setting mode.
Models with one display
15 CR-V-31T0A6300.book 342 ページ ２０１４年１２月１１日 木曜日 午後８時２０分