Haltech E6S - Manual (Page 125)

125
SENSOR PIN OUTS
A BLUE GROUND
B YELLOW PRIMARY TRIGGER
C N/C
D N/C
E GREEN SECONDARY (HOME) TRIGGER
F RED + 12 VOLTS
E6S DIP SWITCH SETTINGS
The E6S factory default internal DIP switch settings should all be in the UP position as
indicated below. Make sure that if you are using a Hall Effect input that the switches are
configured as shown below:
SWITCH POSITION FUNCTION
A UP Disable trigger out from reluctor
B UP Disable input trigger from reluctor
C UP Disable Home out from reluctor
D UP Disable Home in from reluctor
E UP Hall Effect trigger