Haltech E6S - Manual (Page 123)

123
Typical setups (s2)
4 CYLINDER / 2 ROTOR ENGINE
For a four cylinder 3 magnets are required in total. Two north poles positioned exactly 180
°
apart while a south pole needs to trigger the sensor before the trigger for cylinder No 1. The
positioning of the magnet for cylinder one is done the same way as the for the S1 making sure
the north pole is triggering the sensor at approximately 75
°
BTDC.
FIGURE 4: TYPICAL 4 CYLINDER/ 2 ROTOR APPLICATION
6 CYLINDER / 3 ROTOR ENGINE
For a six cylinder 4 magnets are required in total. The two north poles are positioned exactly
120
°
apart while a south pole need to trigger the sensor before the trigger for cylinder No 1.
FIGURE 5: TYPICAL 6 CYLINDER/ 3 ROTOR APPLICATION