E.2.3 adjusting the on-board jumpers – Haltech E6S User Manual

Page 118

Text mode
Original mode

118

Output Signal from the Motronic Sensor

Zero Volts

(Ground)

Output Signal

Zero Volts

(Ground)

If the wires are reversed and the signal goes negative (-) first, or a rising edge is selected to
trigger the Haltech ECU, then the on-board reluctor adapter will still generate a pulse but it
will not trigger the Haltech correctly resulting in incorrect ignition timing. So please make
sure it is wired correctly.

E.2.3 Adjusting The On-Board Jumpers

•

Remove the 4 phillips head screws from the endplate opposite to the main connector.

•

Slide the lid off the enclosure.

JUMPER LOCATIONS

JUMPERS

DIP SWITCHES

MAIN CONNECTOR

J11

J10